Strange E169

9eor9 · **Strange E169 -** 24-09-2010, 10:15

Hi,

wanted to update a Base E169 stick (already debranded) to FW 11.314.07.00.52 (downloaded from/via 3g-modem.wetpaint.com) and higher, but did not succeed. Hardware CD57TCPU.

Original problem was that the speed shown never came over 384kBit/s in all networks I used and whereever I was.
1st of all not all USB connectors liked the stick. Then XP detected the device, but not the Mobile Partner.

When I ran the update wizard, an error message came "Terminal plugged not firmware, the wizard can work on - update failure" or "IMEI error".

After that process the Mobile Partner Diagnostics shows the new FW version, but this changes after some time (plug/unplug/hibernate/launch again) automatically to the old version.

I tried with another XP machine, there the update wizard asked for a 8-digit PIN ("Firmware not compatible to installed version - Please enter PIN").

I plugged to a Vista laptop, nothing happened. An E220 was detected flawlessly.

WHAT IS WRONG WITH THAT STICK????

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

	(#1)
9eor9 (Offline) Senior Member Prepaid Expert Posts: 223 Join Date: 10 Apr 2009 Country:	Strange E169 - 24-09-2010, 10:15 Hi, wanted to update a Base E169 stick (already debranded) to FW 11.314.07.00.52 (downloaded from/via 3g-modem.wetpaint.com) and higher, but did not succeed. Hardware CD57TCPU. Original problem was that the speed shown never came over 384kBit/s in all networks I used and whereever I was. 1st of all not all USB connectors liked the stick. Then XP detected the device, but not the Mobile Partner. When I ran the update wizard, an error message came "Terminal plugged not firmware, the wizard can work on - update failure" or "IMEI error". After that process the Mobile Partner Diagnostics shows the new FW version, but this changes after some time (plug/unplug/hibernate/launch again) automatically to the old version. I tried with another XP machine, there the update wizard asked for a 8-digit PIN ("Firmware not compatible to installed version - Please enter PIN"). I plugged to a Vista laptop, nothing happened. An E220 was detected flawlessly. WHAT IS WRONG WITH THAT STICK???? Last edited by 9eor9; 24-09-2010 at 10:53..